Components of Bus duct

Insulation support ---- is an integral part of the busway equipment, used to support the conductors in the busway equipment. Mounting Plates - Plates used to support various components and suitable for installation in a complete set of equipment. Mounting Frame----A frame used to support various components and suitable for installation in a complete set of equipment. Enclosure---------The enclosure is a component that protects the device from some external factors and keeps the device from being directly touched in all directions, and its protection level is at least IP30. DOOR------------A hinged or slidable cladding. Cover plate -------- is the upper and lower shell surfaces of the shell, usually refers to a part on the busway equipment, which is used to cover the opening on the shell. Fix it with screws or similar methods, and generally do not disassemble it after the equipment is put into operation. The side plate -------- is the left and right shell surfaces of the shell, usually refers to a part on the busway equipment, which is used to cover the opening on the shell. Fix it with screws or similar methods, and generally do not disassemble it after the equipment is put into operation. Insulating barrier—a component used to protect against direct contact from all directions at the entrance and arcs from switching devices and similar devices. Live parts—conductors or conductive parts used to carry electricity in normal use, including neutral conductors, but excluding neutral protective conductors. Bare Conductive Part—An accessible conductive part of electrical equipment that is not normally energized but may be energized in the event of a fault. Protective conductor—a conductor that is electrically connected to the following components to prevent the risk of electric shock. Special reminder: The cable is expressed according to the cross-section, and the busway is expressed according to the rated working current (generally said 400A busway). The same 400A domestic product has a cross-section of 240mm, and some are only 180mm. The difference is too large, so there are some 1.4 yuan/Axm, 2.0 yuan/Axm, and higher. It is recommended to ask the manufacturer to provide a description of the insulation method and mark the busbar specifications to avoid being fooled.